Bauknecht SLZK 5644 WS Instrucciones de uso Pagina 17

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 27
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 16
USING THE ELECTRONIC PROGRAMMER
AUTOMATIC COOKING
(Fig. 10.7-10.8)
To cook food automatically in the oven and on the
radiant zones the following steps are necessary:
1. Set the length of cooking time.
2. Settheendofthecookingprocess.
3. Set the temperature and cooking program.
Proceed as follows:
1. Set the length of cooking by pressing key
and key
+
or
(Fig. 10.7). (Key
+
increase, key
decrease).
AUTO and symbol
are lit up.
2. Settheendofcookingbypressingkey
and key
+
(fig. 10.8) (the cooking time is added to the clock
time). If the time required is exceeded, it can be set
back by means of key
-
.
When the setting is ended switch symbol
off.
If after the setting AUTO flashes and a s ignal sounds
this means that there was a mistake in the
programming, because the length of cooking has
been set wrongly in relation to the clock time.
In this case correct the end of cooking t ime or the
length of cooking; perform the steps described above
again.
3. Set the temperature and cooking program with the
corresponding switch and the thermostat knob (see
corresponding section).
Only the oven is programmed; it switches on
automatically at the right time and switches off again
afterthesettime.
During cooking symbol
is lit up.
The time remaining until the end of cooking can be
read by pressing key
.
(10.7)
(10.8)
The cooking program can be cancelled at any
time by pressing key
.
When cooking is complete the appliance switches off
and symbol
and AUTO flashes and the signal
sounds; the signal can be switched off by pressing any
key.
Set the switch and the thermostat knob to 0 and set
the programmer to “manual” by pressing key
.
Warning: If there is a power cut the clock switches
back to 0 and the programming is cancelled. In a
power cut three zeros flash on the display.
45
Vista de pagina 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 26 27

Comentarios a estos manuales

Sin comentarios